Yeswelder CT2050, Operator'S Manual

Page: 30 / 56

Set Up for Plasma Cutting
Ÿ Connect the Cutting torch to the Torch Connector.
Ÿ
Plug the 5-pin torch control switch cable into to Trigger Connector Receptacle.
Ÿ
Connect the work clamp to the Po) Output Receptacle, ensure it has good contact with the workpiece on a clean, bare
metal surface free of rust, paint, or coating. Note: Wrong connection for work clamp will lead to machine damage.
Ÿ
Install the air filter regulator and connect between the air inlet and air compressor.
Ÿ
Set the air pressure to 60-90PSI.
Ÿ
Attach the work clamp to the workpiece that need cutting.
Ÿ
Put the cutting torch away from all conductive materials.
Ÿ Plug the power cable into a suitable power outlet, recommend NEMA6-50R.
Ÿ
Turn on the power source and select Plasma Cut-Built-in Compressor Air/Plasma Cut-Outer Air process with the Welding Process
Selection.
Ÿ
Trigger the torch and make sure there’s the air flow and pilot arc.
Ÿ
Press the Value Knob to set parameters and rotate the knob to adjust the values.
Ÿ Move the torch head to the workpiece and trigger the torch control switch to initiate the arc with blowback technique.
27