Yealink Telkom W52P, Configuration Manual

Page: 77 / 102

Call Features
65
Enter the desired number using the keypad.
Press , or to dial out.
If there are multiple lines assigned to your handset as outgoing lines, press the Line
soft key to select the desired line and then press or the Dial soft key to dial out.
If you do not select a line, the handset uses the default outgoing line to dial out.
To place a new call during an active call via the handset:
You can place at most two calls on your handset.
1. Press the Ext.Call soft key.
The active call is placed on hold.
2. Enter the desired number in the Call To field using the keypad.
3. Press , or to dial out.
Note
For security reasons, W52P IP DECT phones support off hook hotline dialing feature.
When the user dials out a call using a line with this feature enabled, the IP phone will
first dial out the preconfigured number to the SIP server the line registers to.
The SIP server may prompt the user to enter an activation code for call service. After the
user enters a valid activation code, the IP phone will use this line to dial out a call
successfully. If the entered activation code is invalid, the user cannot use this line for call
service.
Note
This feature is disabled by default and configurable only via the configuration files. For
more information on how to configure this feature, refer to
Yealink_W52P_IP_DECT_Phones_Auto_Provisioning_Guide
.
This feature is not applicable to IP call and intercom call. That is, even if Off Hook hot
line dialing feature is enabled, you can place an IP call or intercom call normally.
You can answer a call in three ways:

Using the earpiece

Using the speakerphone
You can also make an IP call by directly dialing the IP address of any IP phone. For
example, IP: 192.168.1.15.
The server actions may vary on different servers.
Contact your system administrator for the activation code.