PVI 36TL Installation and Operation Manual (Rev H)
DOCR-070588-H
Page
75
of
120
GridV.OutLim
Figure 4.6 - Fault Indication Interface
LCD will display different mode interfaces based on the operation modes of the
inverter. There are four operation modes:
startup
system check mode (as shown in
Figure 4.3),
stand-by
mode (as shown in Figure 4.4),
normal operation
mode (as
shown in Figure 4.5, the switching time between (a) and (b) is 5 seconds), and
fault
mode (as shown in Figure 4.6).
The default indication interface mainly indicates PV voltage, PV current, grid
voltage, instant power, daily generated power and time information under normal
operation.
The fault information of the most recent / current fault will be indicated on the
LCD when the inverter is in fault mode.
4.4 Menu functions
LCD displays “default indication interface” when the inverter is in operation
mode. Press
ESC
in this interface to escape the default interface and enter the main
operation interface. The main operation interface is shown in Figure 4.7.
1 OP.Info
2 Alarm
3 History
4 Setting
→
5 Dispatch
Figure 4.7 - Main Menus on the LCD
The users may select options with
UP
and
DOWN
, and then press
ENT
to confirm
selection. The users can return to the default indication interface by pressing
ESC
.
4.4.1 Operation information
When the cursor moves to “1 OP. Info” in the main screen, you should press
ENT
to select the operation information as shown in Figure 4.8. Check the information by
pressing
UP
and
DOWN
. Return to the previous menu by pressing
ESC
.
