Yamato WA Series, Instruction Manual

Page: 11 / 53

Control Module with Arm
Maximum weight requirement for reticulating control arm is 30 lbs.
For wall mount of control arm make sure that a stud or plywood backing
is used for proper mounting.
Remove plastic screw covers from Arm
Using a level and measuring tape, mark three holes as shown. Drill a
pilot hole using 3/16” drill bit and drill 2.2” deep
ARM MOUNT BRACKET
HOLE TEMPLATE
Mount the reticulating arm with the hardware provided. Re-
attach plastic covers.
Tension of the arm can be adjusted using the allen key provided.
These are located at the three pivot joints.
The tubing and electrical bundle is approximately 1” in diameter.
If a penetration through a sink is needed for an “under the sink”
configuration, a minimum of 1-1/2” hole is required for the
fluidics/electrical bundle. Use an appropriate hole saw for the
countertop material of construction. Approximately 8 feet of
tubing and electrical is provided. Installer can trim down the
tubing to eliminate excess but make sure there is enough slack
to allow for full range of motion of the reticulating arm and
enough slack to remove the system for routine maintenance and
repairs. Electrical cannot be modified. Make the termination
points at the side, base system.
SIDE VIEW OF REMOTE
ARM WITH BASE
9
REMOTE CONFIGURATION – CONTROL UNIT WITH ARM
INSTALLATION