![background image](http://html.mh-extra.com/html/yamato/ba300/ba300_instruction-manual_905286029.webp)
26
4. OPERATION PROCEDURES
Pattern Repeat Function
Setting program
repeat function
This section illustrates how to use the repeat function (repeat a
program pattern) in a programmed operation.
Set program repeat
The following illustration continues from
⑪ of Step 4,
“
Enter
program
,
” above.
This procedure sets the step number to be repeated, "PS_x", and
number of times to repeat, "Pc_x" (x = step number)
①
After setting the timer, press the the SUBMENU key (Step 7
in the preceding example). This brings up the repeat function
setting mode.
②
Top display will show "PS_x", indicating the step to be repeated
in the program pattern.
would be shown in the
example above, since repeat function is used at the seventh
step. Step numbers 1 to 7 can be entered into the center
display. Enter the number (1 in the example) using the
▲▼
keys.
③
Press the SUBMENU key.
Top will show "Pc_x", indicating the number of times to repeat.
Enter this value (2 in the example) into the center display with
the
▲▼ keys.
④
Screen proceeds to the next step when the SUBMENU key is
pressed again.
Sv_8 would be displayed next (in the case of example above).
Editing and
confirming settings
Editing settings is not possible while in repeat setting mode.
To edit or confirm the settings, complete current step entry, then press
the FIXED TEMP key, when temperature setting screen for the next
step appears. Display will return to previous screen, where editing can
be done.
Note:
Editing and confirmation must be done in the program setting
screen.
Contact a local dealer or Yamato sales office, if further questions arise
concerning operation procedures.
①
②
Summary of Contents for BA300
Page 2: ......