2-30
SPEC
1
Seat lock cable
2
Carburetor heater lead
3
Carburetor autochoke lead
4
Starter switch lead
5
Starter motor positive lead
6
Starter motor negative lead
7
High tension cord
8
Clamp
9
C.D.I. magneto lead
0
Vacuum sensing hose
q
Joint
w
Carburetor air vent hose
e
Starter air vent hose
r
Wire (positive lead)
A
Pass the sidestand switch
lead under the rear brake
cable and throttle cable 1,2.
B
Pass the sidestand switch
lead under the frame.
C
Pass the throttle cable, wire
harness and rear brake
cable under the frame cross
tube.
D
Pass the thermo switch lead
under the frame.
E
Pass the positive and nega-
tive battery leads through the
slot in the footrest board.
F
Fasten the autochoke lead
and heater lead to the cross
tube and cut the end to be
shorter than 5mm.
G
Fasten the vacuum sensing
hose, starter motor positive
lead, C.D.I. magneto lead
and high tension cord, and
the vacuum sensing hose to
the over position and cut the
end.
H
Clamp the starter motor lead
and C.D.I. magneto lead.
I
Pass the fuel overflow hose
along the left side of the fuel
tank.
J
Route the autochoke lead
and heater lead between
vacuum sensing hose and
fuel cock vacuum hose.
K
Pass the breather hose right
side the throttle cable.
L
Fasten the breather hose,
autochoke lead, heater lead
and throttle cable 1, 2.
Breather hose to the over
position and cut the end.
M
Pass the throttle cable, wire
harness and rear brake
cable outside the inner
fender rib.
CABLE ROUTING
I
1
H
0
9
8
G
7
6
5
4
3
F
2
E
D
C
1
B
A
M
r
L
K
J
e
w
q