CHK
ADJ
CHECKING THE ENGINE OIL LEVEL/
CHANGING THE ENGINE OIL
4. Start the engine, warm it up for several minutes,
and then turn it off.
5. Check the engine oil level again.
TTTTTTTTTTTTTTTTTTTTTTTTTTTTT
T
T
TTTTTT
T
T
T
T
a. Remove the oil filter element cover
1
and oil
filter element
2
.
b. Check the O-rings
3
and replace them if are
found damage.
c. Install the new oil filter element and the oil filter
element cover.
T TT
T TT
T TT
T TT
T TT
T TT
T TT
T TT
T TT
T T
T
T
T TT
T TT
T
T
T
T
Oil filter element cover bolt
10 N.m (1.0 kgf.m, 7.2 ft.lb)
Before checking the engine oil level, wait a
few minutes until the oil has settled.
NOTE:
CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several minutes,
and then turn it off.
2. Place a container under the engine oil drain bolt.
3. Remove:
• Dipstick
• Oil drain bolt
1
• Gasket
4. Drain:
•
engine oil
(completely from the crankcase and oil tank)
5. If the oil filter element is also to be replaced,
perform the following procedure.
3-19
•
Engine oil also lubricates the clutch and the
wrong oil types or additives could cause
clutch slippage. Therefore, do not add any
chemical additives or use engine oils with a
grade of CD
c
c
c
c
c
or higher and do not use oils
labeled “ENERGY CONSERVING II”
d
d
d
d
d
or
higher.
•
Do not allow foreign materials to enter the
crankcase.
CAUTION
:
1
-2-3-4-5
3
1
2
3
Summary of Contents for YBR250 2007
Page 1: ...YBR250 SERVICE MANUAL 5D1 F8197 E0 2007 ...
Page 2: ......
Page 359: ...YAMAHA MOTOR DA AMAZÔNIA LTDA ...
