Yamaha YBR125 Custom, Service Manual, Page: 172 / 218

Steering axle and handle bar
CHAS
Inspection of front steering axle
Procedres for replacement:
Note:
1.
2.
******************
Clean the roller holding bracket and bearing race.
Inspection
Roller holding bracket
Bearing race
Worn,damaged
→ replace
As shown on the fig,remove the bearing race with a long
rod and hammer,take it out from the cencave groove
of fork pipe of steering joint.
As shown on the fig,remove the bearing race of steering
rod with plain chisel and hammer.
Install the new dust seal parts, roller holding bracket
and bearing race.
The roller holding bracket,bearing race and dust
seal parts are always replaced as a complete set.
If the roller holding bracket and bearing race are
installed at a slant,the frame will be worn, so install
them in horizontal condition.
Never beat the roller and rod surface.
************************
******************************************
Installation of steering axle
1.
2.
3
Conduct installation according to the reverse procedures
of "Removal".
Oil filling
Roller holding bracket(upper and lower)
Bearing race
Lithium base lubrication grease
Installation
Ring nut (lower)
Ring rubber pad
Ring nut (upper)
Limit clip
Conduct adjustment after installing, the adjustment
method is conducted as stated in chapter .
6-30