Yamaha WR250FM 2021, Owner'S Service Manual

Page: 39 / 404

MULTI-FUNCTION DISPLAY
1-27
EAM30329
RACE MODE
Putting measurement on standby
TIP
Starting measurement consists of the following
two starts, either of which can be selected.
•
Manual start
Starting measurement by the rider himself op-
erating the button. (A long push on the
“SLCT2” button will put measurement on
standby.)
• Auto start
Starting timer measurement automatically on
detection of the movement of the machine. (A
long push on the “SLCT1” button will put mea-
surement on standby.)
Manual start
TIP
Initial setting at changeover to RACE MODE will
remain for manual start.
1. Check that changeover to RACE MODE has
been made. (Refer to “Changeover from BA-
SIC MODE to RACE MODE”.)
TIP
When the machine is made ready for a run by
manual start, “ ”, “ ”, “
”, and the average
speed display will start flashing.
2. Start timer measurement by pushing the
“RST” button.
3. When stopping timer measurement, pushing
the “SLCT1” button and “SLCT2” button at
the same time.
TIP
If the machine is run while timer measurement is
not made, no change will occur to the digit in trip-
meter A (TRIP A).
4. To resume the measurement, again push the
“SLCT1” button and “SLCT2” button at the
same time.
Auto start
1. Check that changeover has been made to
RACE MODE. (Refer to “Changeover from
BASIC MODE to RACE MODE”.)
2. Make the machine ready for a run by pushing
the “SLCT1” button for 2 seconds or more.
TIP
When the measurement is made ready for a run
by auto start, “ ”, “ ”, “
”, and the average
speed display will start flashing. Timer display
will turn on scrolling from left to right.
3. Run the machine and start timer measure-
ment.
4. To stop timer measurement, pushing the
“SLCT1” button and “SLCT2” button at the
same time.
TIP
If the machine is run while timer measurement is
not made, no change will occur to the digit in trip-
meter A (TRIP A).
5. To resume the measurement, again push the
“SLCT1” button and “SLCT2” button at the
same time.
Resetting measurement data
TIP
Resetting can be made in the following three
manners.