2-35
INSP
ADJ
HEADLIGHT BEAM ADJUSTMENT
ELECTRICAL
HEADLIGHT BEAM ADJUSTMENT
1. Place the machine on a level surface.
2. Place the machine in front of a wall at the recom-
mended distance
D
. Refer to the table below.
3. Measure the distance
H
from the floor to the
center of the headlight and place a mark on the
wall at that height.
4. With a person sitting on the machine, apply the
parking brake, start the engine and let it idle.
5. Switch on the headlight’s high beam and check
the height of the projected beam on the wall. The
projection should be at the position marked in
step 3 or 1/2° lower (set range
S
).
D
3.0 m (10 ft)
7.6 m (25 ft)
S
26 mm (1.0 in)
66 mm (2.6 in)
D
: Distance
S
: Set range
6. Adjust:
•
Headlight beam (vertically)
Vertical adjustment
Higher
Turn the adjusting screw
1
+
2
clockwise.
Lower
Turn the adjusting screw
1
+
2
counterclockwise.
7. Adjust:
•
Headlight beam (horizontally)
Horizontal adjustment
To right
Turn the adjusting screw
1
clockwise or turn the adjusting
screw
2
counterclockwise.
To left
Turn the adjusting screw
2
clockwise or turn the adjusting
screw
1
counterclockwise.
SEA2670
SEA2675
Summary of Contents for VX600ERG
