2-2
INSP
ADJ
PERIODIC MAINTENANCE TABLE
Check oil level.
Replace.
Check deflection.
Adjust if necessary.
Check for wear and damage.
Replace if necessary.
Check operation.
Adjust toe-out if necessary.
Check for damage.
Replace if necessary.
Check operation.
Replace bulbs if necessary.
Check fluid level.
Add only distilled water if necessary.
Check specific gravity and breather hose operation.
Charge/correct if necessary.
Check engagement and shift speed.
Adjust if necessary.
Inspect sheaves for wear/damage.
Inspect weights/rollers and bushings for wear-for pri-
mary.
Inspect ramp shoes/bushings for wear-for secondary.
Replace if necessary.
Lubricate with specified grease.
Lubricate with specified grease.
Lubricate with specified grease.
Lubricate with specified grease.
Lubricate with specified grease.
Check cable damage.
Replace if necessary.
Make sure that the shroud latches are hooked.
Check tightness.
Repair if necessary.
Check for proper placement.
Whenever operating elevation is changed.
Initial at 500 km (300 mi) and every 800 km
(500 mi) thereafter.
Drive chain oil
Drive chain
Skis and ski runners
Steering system
Strap (MM600)
Lights
Battery
(VT600/VX600ER)
NOTE:
Brake fluid replacement:
1. When disassembling the master cylinder or caliper cylinder, replace the brake fluid. Normally check the brake
fluid level and add the fluid as required.
2. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years.
3. Replace the brake hoses every four years, or if cracked or damaged.
Item
Remarks
Pre-
operation
check
(Daily)
Initial
1 month
or
800 km
(500 mi)
(40 hr)
Every
Seasonally
or
3,200 km
(2,000 mi)
(160 hr)
Primary and secondary
clutches
Steering column bearing
Ski and front suspension
Suspension component
Parking brake cable end
and lever end/throttle cable
end
Shroud latches
Fittings and fasteners
Tool kit and recommended
equipment
2
Summary of Contents for VX600ERG
