10
10
C
onnections – U
sing
T
yr
os3 with O
ther D
evices –
Tyros3 Reference Manual •
119
4-3
Use the [4
▲▼
]–[6
▲▼
] buttons to specify the function assigned to the
footswitch (actually the note number), or the function assigned to the
foot controller (actually the control change number). About the func-
tions which can be assigned to the footswitch or foot controller, refer to
4-4
(Only for the FOOT CONTROLLER Setting) Determine the part to which
the function assigned to the foot controller is applied by using the [7
▲▼
]/[8
▲▼
] buttons.
4-5
Use the [F]/[G] buttons to determine the MIDI port which is to be used
when communicating with the MFC10.
Here, the USB port (USB1, USB2) can be selected even though the
MFC10 does not have the USB connector. This is because the computer
can be used instead of the MFC10. (The computer can transmit the
data equivalent to the data the MFC10 transmits to the Tyros3. For
details, see the bottom of the page.)
4-6
Use the [H] (CH SELECT) button to determine the MIDI channel which
is to be used when communicating with the MFC10.
5
Press the [I] (SEND MFC10 SETUP) button to send the settings here
to the MFC10.
6
Disconnect the MIDI cable from the Tyros3 and the MFC10, and con-
nect the MIDI OUT terminal of the MFC10 to the MIDI IN terminal of the
Tyros3 according to the setting above by using a MIDI cable.
7
Operate the MFC10 to confirm whether you can properly control the
Tyros3 from the MFC10 as set in step 4.
8
Press the [EXIT] button to return to the MIDI template Selection dis-
play and save the settings above to the USER tab.
Actually the pair of the footswitch num-
ber and the note number, the pair of the
foot controller number and the control
change number, and the MIDI channel
for communication set above are trans-
mitted to the MFC10.
NOTE
MIDI IN
MIDI OUT
MFC10
Transmitting note messages
Transmitting control change
messages
Using a computer or another MIDI instrument instead of the MFC10
The following two settings on the MFC10 Page can be saved not to the
MFC10 but to the Tyros3 as a MIDI template.
• Note number/Tyros3 function assignment pairs
• Control change number/Tyros3 parameter change assignment pairs
If you are not using an MFC10, you can have note numbers and control
change messages from any other appropriate MIDI device (such as a com-
puter, sequencer or master keyboard) control the Tyros3. Make sure to set
the appropriate channel in this display for control by the external device.
Summary of Contents for Tyros3
Page 1: ...EN Reference Manual ...
