Yamaha TT-R125(S), Owner'S Service Manual

Page: 232 / 610

3 - 30
INSP
ADJ
STEERING HEAD INSPECTION AND ADJUSTMENT
●
Install the upper bracket A , steering stem
nut
B
, cap
C
, handlebar
D
, upper han-
dlebar holder E , starter knob nut F and
number plate G .
NOTE:
●
The upper handlebar holder should be
installed with the punched mark
a
for-
ward.
●
Insert the end of fuel breather hose H into
the hole of the starter knob stay.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
T
R
.
.
Pinch bolt (upper bracket):
25 Nm (2.5 m • kg, 18 ft • lb)
Steering stem nut:
110 Nm (11.0 m • kg, 80 ft • lb)
Handlebar upper holder:
23 Nm (2.3 m • kg, 17 ft • lb)
Starter knob nut:
1 Nm (0.1 m • kg, 0.7 ft • lb)
Number plate:
7 Nm (0.7 m • kg, 5.1 ft • lb)
TT-R125E/TT-R125LWE
●
Steering ring nut
Steering ring nut adjustment steps:
●
Remove the number plate and starter
knob.
●
Remove the main switch, handlebar and
upper bracket.
●
Remove the special washer 1 .
●
Remove the upper ring nut 2 , and rubber
washer 3 .
●
Loosen the lower ring nut 4 using the
steering nut wrench 5 .
Steering nut wrench:
YU-33975/90890-01403