Reference Manual
Reference
83
Velocity Limit Lo/Hi (Velocity Limit Low/High)
Determines the minimum and maximum values of the velocity range within which each Part will respond. Each Part will
only sound for notes played within its specified velocity range. If you specify the maximum value first and the minimum
value second, for example “93 to 34,” then the velocity range covered will be “1 to 34” and “93 to 127.”
Settings:
1 – 127
NOTE:
You can also set the Velocity value directly from the Keyboard, by holding down the [SHIFT] button and pressing a key.
Split Lo/Up (Split Lower/Upper)
Determines which area of the keyboard will produce the sound. When “upper” is selected, the notes of the Split Point
(Common parameter) or upper will produce the sound. When “lower” is selected, the notes lower than the Split Point
(Common parameter) will produce the sound. When “both” is selected, all the notes of the entire keyboard will produce
the sound. Actually, the sound is produced by playing the notes within the area that matches both the settings here and
the Note Limit setting.
Settings:
both, lower, upper
Porta Sw (Portamento Switch)
Determines whether Portamento is applied to each Part or not.
Settings:
off, on
NOTE:
For Parts to which the Drum Voice is assigned, this parameter is not available.
Porta Time (Portamento Time)
Determines the pitch transition time. Higher values result in a longer pitch change time, or a slow speed.
Settings:
0 – 127
NOTE:
For Parts to which the Drum Voice is assigned, this parameter is not available.
Porta Mode (Portamento Mode)
Determines how Portamento is applied to your keyboard performance.
Settings:
fingered, fulltime
NOTE:
For Parts to which the Drum Voice is assigned, this parameter is not available.
Output Select
Determines the specific output(s) for the individual Part. The following settings are available. You can assign each
individual Part sound to be output from a specific hardware output jack on the rear panel.
NOTE:
The Reverb Send, Chorus Send and Dry Level parameters are not available when Output Select is set to something other than
“L&R.”
Settings:
L&R, asL&R, asL, asR, drum (only Drum Voice)
Vel Sens Depth (Velocity Sensitivity Depth)
Determines the degree to which the resulting volume of the tone
generator responds to your playing strength. The higher the value, the
more the volume changes in response to your playing strength (as
shown at the right). When this is set to 0, the volume remains the same
no matter how strongly or softly you play. This would be useful, for
example, for authentic playing of an Organ Voice.
Settings:
0 – 127
fingered
Portamento is only applied when you play legato (playing the next note before releasing the previous one).
fulltime
Portamento is applied to all notes.
127
0
127
When Offset (below) is set to 64:
Depth=127
Depth=64
Depth=32
Depth=0
Velocity with which
you play a note
Actual resulting
velocity
(affecting the tone
generator)
