Reference Manual
Reference
82
Volume
Adjusts the Volume for each Part. Use this parameter to adjust the balance between the current Part and other Parts.
This parameter can be changed directly via the Slider.
Settings:
0 – 127
Pan
Determines the stereo pan position for the Part. This parameter can be changed directly via the Slider.
Settings:
L63 (far left) – C (center) – R63 (far right)
NOTE:
Note that this Part Pan parameter may have little or no audible effect if the Pan for a specific Element of the Voice is set to the left
position and the Pan for another Element is set to the right position.
Voice Elm Pan (Voice Element Pan)
Determines whether the individual pan settings for each Element (of the Voice assigned to the selected Part) are
applied or not. When this is set to “off,” the basic pan position for the selected Part is set to center.
Settings:
on, off
Assign 1 Value
Assign 2 Value
Determines the offset value by which the functions assigned to the Assign 1/2 knobs will be shifted from their original
settings. This parameter can be changed via the Knob directly.
Settings:
-64 – +0 – +63
Note Shift
Adjusts the pitch of the Part in semitones.
Settings:
-24 – +0 – +24
Detune
Adjusts the tuning of the Part in 0.1 Hz increments.
Settings:
-12.8Hz – +0Hz – +12.7Hz
PB Range Upper (Pitch Bend Range Upper)
PB Range Lower (Pitch Bend Range Lower)
Determines the maximum Pitch Bend range in semitones. Setting the Upper parameter to +12 would result in a
maximum pitch rise of one octave when the Pitch Bend wheel is moved upwards. On the other hand, a Lower setting of
-12 would result in the pitch being lowered up to a maximum of one octave when the Pitch Bend wheel is moved
downwards.
Settings:
-48semi – +0semi – +24semi
Mono / Poly
Selects whether the Voice of the Part is played monophonically (only one note at a time) or polyphonically (multiple
notes sounding simultaneously).
Settings:
mono, poly
NOTE:
For Parts to which the Drum Voice is assigned, this parameter is not available.
Note Limit Lo/Hi (Note Limit Low/High)
Sets the lowest and highest notes of the keyboard range for each Part. Each Part will only sound for notes played within
its specified range. If you specify the highest note first and the lowest note second, for example “C5 to C4,” then the
note range covered will be “C -2 to C4” and “C5 to G8.”
Settings:
C -2 – G8
NOTE:
You can also set the Note directly from the Keyboard, by holding down the [SHIFT] button and pressing the desired key.
2 Play Mode
mono
When set to “mono,” the selected Voice is played back monophonically (only a single note is played back
simultaneously). For many instrument sounds (such as bass and synth lead), this allows a more natural and smooth
sounding legato performance than when this parameter is set to “poly.”
poly
When set to “poly,” the selected Voice is played back polyphonically (multiple notes can be played back simultaneously
or a chord is played back).