Yamaha RIVAGE PM10, Systems Setup Manual

Page: 23 / 56

RIVAGE PM10 System Setup Guide
23
)
Fader
This is a touch-sensitive 100mm motorized fader. In
SENDS ON FADER mode, this fader adjusts the send
level of the signal sent from each channel to the
currently-selected MIX/MATRIX bus.
!
SAFE R indicator
Lights if the channel is set to Recall Safe.
@
SAFE M indicator
Lights if the channel is set to Mute Safe.
#
ISOLATE indicator
Lights if the channel is “Isolated.”
$
[CUE] key
Selects the channel for cue.
1 PIN indicator
Lights when the Pinning function for the [TOUCH
AND TURN] knob is ON.
(This feature will be supported by a future update.)
2 [TOUCH AND TURN] knob
Controls the parameter of the knob you are touching
on the touch screen. The color of the LED beneath
this knob will match the color of the selected knob on
the touch screen.
3 Channel strip encoder display
Indicates the function that has been assigned to the
channel strip encoder.
4 UP [ U ]/DOWN [ D ] keys
Enable you to select the function that you want to
control using the channel strip encoder.
5 [SHIFT] key
Combine with another key to perform a certain
function.
The following table shows examples of using the
[SHIFT] key combined with another key. For more
information, please refer to the Operation Manual.
6
[SENDS ON FADER] key
Turns SENDS ON FADER mode on and off.
7
INPUT [1-72]/[73-144] keys
Enable you to select an input layer.
8
OUTPUT [MIX]/[MATRIX] keys
Enable you to select an output layer.
9
[DCA] key
Enables you to select a DCA layer.
)
CUSTOM [1]/[2] keys
Enable you to select a custom layer. You can assign
custom faders of two banks (total of 12 layers) to each
custom layer.
!
Layer display
Indicates the selected layer.
1
3
5
6
7
8
9
)
!
#
2
@
4
Procedure Function
Press and hold down the
[SHIFT] key and [CUE]
key. To switch cues as the
channel’s send destination.
(A
➝
B
➝
A&B
➝
A)