Yamaha Programmable Mixer 01, User Manual

Page: 94 / 154

86
Chapter 9: MIDI
ProMix 01 User’s Guide
1. Press [MIDI].
The MIDI menu appears.
2. Select LOCAL ON/OFF and
press [ENTER].
The LOCAL ON/OFF LCD func-
tion appears.
3. Press [ENTER] or use the
PARAMETER wheel to turn
LOCAL ON/OFF ON and
OFF.
4. Use the cursor buttons to
select the LOCAL ON/OFF
parameter and the [ENTER]
button to set it.
5. To exit this function and
return to the MIDI menu,
select EXIT and press
[ENTER], or just press
[MIDI].
The MIDI menu reappears.
!
Make sure that PROGRAM Tx
and CONTROL Tx are set to
ON. Otherwise, Control Change
and Program Change messages
are not output. Go to the MIDI
SETUP LCD function.
Local ON/OFF
The LOCAL ON/OFF LCD function allows you to use the ProMix 01
faders and CH1–16 [SEL] buttons to control another ProMix 01, or
a MIDI device that responds to MIDI Control Change and Program
Change messages. This is similar to the Local ON/OFF function of a
synthesizer, where the keyboard is disconnected from the tone gen-
erator so that both parts can be used independently. Using the
ProMix 01 faders you could, for example, control parameters on a
synthesizer or effects processor. The ProMix 01 [SEL] buttons could
be used to select voices, programs, patches, etc., on a MIDI device.
Shown below is the LOCAL ON/OFF LCD function. Faders are listed
in two boxed rows. Each box contains the fader’s number and its cur-
rent position, specified as a hexadecimal MIDI value.
LOCAL ON/OFF — this turns the Local function ON and OFF.
When set to ON, the faders and [SEL] buttons control the ProMix 01
as normal. When set to OFF, the faders and [SEL] buttons do not con-
trol the ProMix 01 (i.e. Edit Buffer). When a fader is moved, a Control
Change message is output, and when a CH1–16 [SEL] button is
pressed, a Program Change message is output. The message “Program
Change Transmitted” appears when a [SEL] button is pressed. The ST
IN, RTN/SEND, and ST OUT faders are set to minimum automati-
cally.
When Local is set to OFF, ProMix 01 can still be controlled by another
device using Control Change messages. The Control Change to
Parameter Assignment table in the Additions section of this User’s
Guide lists the initial parameter assignments.
Once the LOCAL ON/OFF parameter has been set to OFF, you can
toggle between Local Off mode and normal operation very quickly.
Simply press a function button to go to another LCD function. Then,
to return to Local Off mode, just press the [MIDI] button.
When ProMix 01 is powered ON, Local ON/OFF is set to ON auto-
matically.
Note: Local OFF is effective only when the MIDI LOCAL ON/OFF LCD
function is selected. When another LCD function is selected, the faders
and [SEL] buttons control the ProMix 01 as normal.