55
Parameters /
Setup Detail Parameter Window
Ribbon Controller-Z (for AN1x data compatibility)
For controlling with Z-axis motion on a ribbon controller (push-release), and/or by
incoming MIDI messages of Control Change number 12.
AN AC 1 - 8
For controlling with a specified Assignable Controller. (Refer to the instructions on
using Assignable Controllers in the owner’s manual of your particular tone generator.
• The available Source for assignment may differ, depending on the selected Parameter. For
details of available parameters, see the table of Control Matrix parameters in the PLG150-AN
Owner’s Manual.
• You cannot assign the same Source controller and Parameter to more than one set. If you
attempt to do so, lower-numbered sets will take priority.
• The control change numbers for AN AC 1-4 can be set with the AN Native parameters (on the
panel of the “mother” device). Each Preset Voice has four pre-assigned control change num-
bers using this function (refer to the AN Voice List in the PLG150-AN Owner’s Manual).
• The Control Change numbers for the Mod Wheel, Foot Volume, Foot Control, Footswitch, Rib-
bon Controller-X, Ribbon Controller-Z and AN AC 5-8 can be set from the AN1x System
Parameters (refer to the MIDI Data Format section in the PLG150-AN Owner’s Manual).
• Parameter
Settings:
For a complete list of the Control Matrix’s Parameters, see the PLG150-AN Owner’s
Manual.
When this is set to “Off,” the assigned controller has no effect.
• Depth
Settings:
The available settings may differ, depending on the selected Parameter. For details, see
the table of Control Matrix parameters in the PLG150-AN Owner’s Manual.
This determines the control range of the Source controller. When this is set to “Direct,”
you can directly adjust/edit the parameter assigned to the controller within its original
range.
• Pitch Bend Range Up
• Pitch Bend Range Down
Range: -24 ... +24
These two parameters let you set independently set the Pitch Bend Range for up and
down motion of the pitch bend wheel on a connected MIDI keyboard. In other words, this
allows you to set pitch bend so that moving the wheel up can make a greater (or lesser)
pitch change than moving the wheel down.
