Front and rear panel
15
—Owner’s Manual
Stereo Inputs
H
Level (5/6), (7/8) controls
These controls adjust the level of the signals input from STEREO
INPUT jacks 5/6 or 7/8. These input signals are always sent to the
ST bus, and are mixed with the signals from input channels 1–4
and the playback signals of the tracks.
Monitor/Master section
I
CUE MIX TO STEREO switch
This switch turns the cue mix function on/off. When the switch is
pressed in (
), the CUE MIX indicator in the display will light,
and the signal from the CUE bus will be mixed into the ST bus.
The cue mix function can be used only during playback, and is
normally used when adding sounds during mixdown (page 42).
J
MONITOR SELECT switches
These switches select the signal that will be monitored from the
MONITOR OUT jacks (rear panel
4
) and the PHONES jack
(front panel
1
). When the switch is pressed in, the
corresponding source is selected (on). When the switch is up, the
signal will not be selected (off). The three switches can be turned
on/off independently.
2TR IN
................... Monitor the signal that is input from the 2TR
IN jacks (rear panel
6
).
STEREO
............... Monitor the ST bus signal that is output from
the STEREO OUT jacks (rear panel
5
).
CUE
....................... Monitor the CUE bus signal.
K
MONITOR LEVEL control
This control adjusts the output level of the monitor signal that is
sent to the MONITOR OUT jacks (rear panel
4
) and the
PHONES jack (front panel
1
).
L
STEREO fader
This adjusts the output level of the ST bus that is output from the
STEREO OUT jacks (rear panel
5
). The fader will be at unity
gain when located between 7 and 8.
Unity gain
: Refer to the explanation of
7
Fader.
5 / 6
7 / 8
0
10
0
10
8
STEREO
MONITOR LEVEL
CUE
STEREO
2TR IN
CUE MIX TO STEREO
MONITOR SELECT
10
9
8
7
6
5
4
3
2
1
0
10
9
8
7
6
5
4
3
2
1
0
MIN
MAX
9
K
L
J
