INSP
ADJ
R-53
ENGINE OIL LEVEL INSPECTION/
ENGINE OIL REPLACEMENT
ENGINE OIL LEVEL INSPECTION
1. Stand the Motorcycle on a level surface us-
ing the Center Stand.
NOTE:
Make sure the Motorcycle is upright when in-
specting the oil level.
2. Start the Engine and let it warm up for a few
minutes.
3. Turn off the Engine.
4. Remove the Dip Stick ¿ (oil level gauge).
Wipe off the Dip Stick (oil level gauge) us-
ing a clean cloth and rest it on the threads
of oil filler hole. Then remove the Dip Stick
(Oil Level Gauge)
5. Inspect:
• Engine oil level
Oil level should be between maximum ¿
and minumim À marks.
Oil level is below the minimum mark Ÿ
Add oil up to the proper level.
RECOMMENDED ENGINE OIL
NOTE :
Wait a few minutes until the oil settles before
inspecting the oil level.
ENGINE OIL REPLACEMENT
1. Start the Engine and let it warm up for sev-
eral minutes or drive approx 4 Kms.
2. Turn off the Engine and place an oil pan un-
der the Engine.
3. Remove :
• Dip stick (oil level gauge)
• Drain plug ¿
• Gasket
Drain the oil from the Crankcase.
3-14
1
8. Install :
• Fuel tank
• Seat
• Side covers
Refer to “SIDE COVERS, SEAT AND
FUEL TANK” section Page no 3-3
YAMALUBE (20W50) Or equivalent
SF grade.
