INSP
ADJ
R-69
FUSE INSPECTION
FUSE INSPECTION
1. Remove:
• Side cover (left)
Refer to “SEAT, SIDE COVERS AND
FUEL TANK” section Page no 3-3
• Fuse holder ¿
2. Inspect :
• Fuse
ææææææææææææææææææææææææææææææææææ
Inspection steps :
• Connect the Multimeter to the fuse and check
it for continuity.
NOTE :
Set the multimeter selector to “Ohm x 1 resis-
tance ” position.
ææææææææææææææææææææææææææææææææææ
• If the Multimeter is indicates non continuity
Ÿ Replace the fuse.
3. Replace :
• Blown Fuse
ææææææææææææææææææææææææææææææææææ
Replacement steps:
• Turn off the Main Switch.
• Install a new fuse with the proper current rat-
ing.
• Turn on switches to verify operation of related
electrical deveces.
• If the fuse blows again immediately, check the
electrical circuit.
ææææææææææææææææææææææææææææææææææ
4. Install :
• Fuse holder
• Side cover (left)
Refer to “SEAT, SIDE COVERS AND
FUEL TANK” section Page no 3-3
3-30
WARNING
CAUTION:
Always turn off the Main Switch when checking
or replacing the Fuse. Otherwise, a short circuit
may occur.
Multimeter
WARNING
Never use a Fuse with a rating other than
that specified. Never use other materials in
place of a Fuse. An improper Fuse may
cause extensive damage to the electrical
system, malfunction of lighting and ignition
and could possibly cause a fire.
Fuse Ampearage :
10A
MAX
MIN
1
2
