Yamaha GRIZZLY Ultramatic YFM660FP, Service Manual

Page: 98 / 408

3 - 21
CHK
ADJ
ADJUSTING THE STARTER CABLE
1.Remove:
●
Seat
●
Fuel tank side panel (left)
2.Adjust:
*****************************************************
Adjustment steps:
●
Disconnect the starter cable
1
from the car-
buretor body.
NOTE:
Do not remove the starter plunger
2
from the
starter cable.
●
Measure the starter plunger stroke distance
a
of the starter lever
3
fully close to fully
open position. If the distance is out of specifi-
cation adjust it as described below.
È
Fully closed position
É
Fully open position
●
Pull back the boot
4
.
●
Loosen the locknut
5
.
●
Turn the adjuster
6
in or out until the correct
distance is obtained.
●
Tighten the locknut
5
.
●
Push in the boot
4
.
●
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the handle-
bar to right and left, and make sure that the
engine idling speed dose not increase.
*****************************************************
3.Install:
●
Fuel tank side panel (left)
●
Seat
Starter plunger stroke distance:
15 mm (0.59 in)
Turning in Distance increased.
Turning out Distance decreased.
ADJUSTING THE STARTER CABLE/
CHECKING THE SPARK PLUG