Yamaha FZS600'98, Service Manual

Page: 35 / 364

2-13
MAINTENANCE SPECIFICATIONS
SPEC
NOTE:
Part to be tightened Thread size
Tightening
torque
Remarks g
Nm m kg
Side cover and frame M6 1.0 4 0.4
Garb bar M8 1.25 19 1.9
Front wheel axle M16 1.5 67 6.7
Front wheel axle pinch bolt M8 1.0 20 2.0
Front brake caliper M8 1.25 40 4.0
Front brake disc M8 1.25 23 2.3
Front brake caliper bleed screw M7 1.0 6 0.6
Compression bar M8 1.25 23 2.3
Rear wheel sprocket M10 1.25 60 6.0
Drive chain puller nut M8 1.25 16 1.6
Rear brake caliper and caliper bracket M10 1.25 40 4.0
Rear wheel axle nut M18 1.5 117 11.7
Rear brake hose union bolt M10 1.25 30 3.0
Rear brake caliper bleed screw M7 1.0 6 0.6
Rear brake disc M8 1.25 23 2.3
Sidestand M8 1.25 23 2.3
Bracket footrest and frame M8 1.25 28 2.8
Rear master cylinder and bracket M8 1.25 23 2.3
Footrest bracket and footrest M10 1.25 55 5.5
Footrest bracket (rear) and frame M8 1.25 28 2.8
Center stand nut M10 1.25 56 5.6
Footrest bracket and exhaust pipe M8 1.25 20 2.0
Footrest bracket (rear) and muffler M10 1.25 30 3.0
1. First, tighten the ring nut (lower) approximately 52 Nm (5.2 m kg) by using the torque wrench, then
loosen the right nut completely.
2. Second, tighten the ring nut (lower) approximately 18 Nm (1.8 m kg) by using the torque wrench,
then finger tighten the ring nut (center). Align the slots both ring nut and install the lock washer.
3. Final, hold the ring nuts (lower and center) and tighten the ring nut (upper) 110 Nm (11.0 m kg) by
using the torque wrench.