EMBRAGUE
5-40
2.
Check:
•
Primary drive gear
Damage / wear
Replace יו
gear
primary drive and clutch as a whole.
Excessive noise during operation
יו
Replace the primary drive gear and the clutch
as a whole.
3.
Install:
•
Primary Drive Gear See "BALANCER
SPROCKET" on page 5-49.
PRIMARY DRIVEN GEAR INSPECTION
1.
Check:
•
Primary driven gear "1"
Damage / wear
Replace יו
gear
primary drive and clutch as a whole. Excessive
noise during
operation
Replace יו
drive gear
primary and the clutch as a whole.
NOTE:
Make sure the corners with sharp edges of the thrust
washer "a" is placed opposite the clutch disc
holders.
1
to
3.
Install:
•
Clutch disc carrier
"1"
•
Lockwasher "2"
New
•
Nut caddy
NOTE:
•
Lubricate the threads of the nut and clutch disc
holder contact surfaces of the lock washer with
engine oil.
1
•
Align the notch "a" in the washer with a lower rib
"b" in the tray clutch.
New
2
1
CLUTCH ASSEMBLY
1.
Install:
•
Conical spring washer "1"
NOTE:
Install the conical washer, as shown in the
illustration.
b
to
4.
Tighten:
•
Caddy clutch nut "1"
1
Clutch Nut caddy
70 Nm (7.0 m · kg, 50 ft · lb)
NOTE:
While holding the tray clutch "2" with the clutch
holder "3", press the
caddy clutch nut.
2.
Install:
•
Clutch Bell
Clutch Holder
YSST-733
•
Thrust washer "1"
