Yamaha FJR1300R, Service Manual

Page: 81 / 572

2 - 21
SPEC
TIGHTENING TORQUES
NOTE:
*1:Tighten the cylinder head bolts to 25 Nm (2.5 m • kg, 18 ft • lb) in the proper tightening sequence,
loosen and retighten the cylinder head bolts to 25 Nm (2.5 m • kg, 18 ft • lb) in the proper tighten-
ing sequence, and then tighten the cylinder head bolts further to reach the specified angle 180°
in the proper tightening sequence.
*2:Tighten the crankcase bolts to 20 Nm (2.0 m • kg, 14 ft • lb) in the proper tightening sequence,
loosen and retighten the crankcase bolts to 20 Nm (2.0 m • kg, 14 ft • lb) in the proper tightening
sequence, and then tighten the crankcase bolts further to reach the specified angle 120° in the
proper tightening sequence.
*3:Tighten the connecting rod nuts to 20 Nm (2.0 m • kg, 14 ft • lb), and then tighten the connecting
rod nuts further to reach the specified angle 120°.
Thermostat assembly Torx screw M6 1 10 1.0 7.2
Thermostat housing cover Bolt M6 2 10 1.0 7.2
Water pump Bolt M6 3 12 1.2 8.7
Water pump housing cover Bolt M6 1 10 1.0 7.2
Coolant drain bolt — M6 1 10 1.0 7.2
Muffler joint Bolt M8 2 20 2.0 14
Muffler Bolt M10 2 25 2.5 18
Exhaust pipe Nut M8 8 20 2.0 14
Exhaust pipe Bolt M8 2 17 1.7 12
Exhaust check bolt — M6 4 10 1.0 7.2
O
2
sensor — M18 1 45 4.5 32
Starter motor Bolt M6 2 10 1.0 7.2
Part to be tightened Part name
Thread
size
Q’ty
Tightening torque
Remarks
Nm m·kg ft·lb