Yamaha FJR1300R, Service Manual

Page: 539 / 572

8 - 43
– +
ELEC
SIGNALING SYSTEM
EAS00753
YES
NO
YES
NO
3. Starting circuit cut-off relay
• Disconnect the starting circuit cut-off relay
from the wire harness.
• Connect the pocket tester (
Ω ×
1) to the
starting circuit cut-off relay terminals as
shown.
• Check the starting circuit cut-off relay for
continuity.
Tester positive probe
→
sky blue
1
Tester negative probe
→
light green
2
Continu-
ity
Tester positive probe
→
light green
2
Tester negative probe
→
sky blue
1
No conti-
nuity
NOTE:
@
When you switch the positive and negative
tester probes, the readings in the above chart
will be reversed.
@
• Are the tester readings correct?
Replace the starting
circuit cut-off relay.
Lg
L / G L / Y Sb B / Y L / W
R / B L / W
1
2
4. Voltage
• Connect the pocket tester (DC 20 V) to the
meter assembly coupler as shown.
Tester positive probe
→
brown/red
1
Tester negative probe
→
light green
2
• Set the main switch to “ON”.
• Measure the voltage (12 V).
• Is the voltage within specification?
Replace the wind-
shield drive unit. The wiring circuit
from the main switch
to the meter assem-
bly coupler is faulty
and must be
repaired.
R / W G / W Y / L Lg Y Ch Dg L
R / G B / W
Br / R
W