Yamaha F50F, Owner'S Manual

Page: 44 / 110

Instruments and indicators
38
even if the cooling water pressure sensor is
not installed, the cooling water pressure dis-
play can be shown by connecting an optional
sensor to the unit. For the optional sensor,
consult your Yamaha dealer. The tachome-
ter unit is available in round or square types.
Check your tachometer unit type.
EMU36190
Start-up checks
Place the remote control lever / gear shift le-
ver in neutral and turn the main switch to
“
” (on). After all the displays come on and
the total hour display comes on, the gauge
will change to normal operation. If the buzzer
sounds and the water separator-alert indica-
tor blinks, consult your Yamaha dealer im-
mediately.
TIP:
To stop the buzzer, press the “ ” (set) or
“ ” (mode) button.
EMU37690
Adjusting trolling speed
You can adjust the trolling speed randomly
by increasing or decreasing it approximately
50 r/min. When in the trolling speed setting
mode, the display switches to the normal dis-
play when the engine speed is increased
(within 3000 r/min) using the throttle. When
the throttle is closed, the display returns to
the trolling speed setting mode. For details,
see the attached operation manual.
TIP:
●
Trolling is affected by currents and other
operating conditions and may differ from
the actual engine speed.
●
The default engine idle speed is reset au-
tomatically when the display is switched to
the normal display. The default engine idle
speed is also reset automatically when the
engine is turned off or when the engine
speed exceeds 3000 r/min.
1. Set button
2. Mode button
1. Tachometer
2. Trim meter
3. Multifunction display
4. Cooling water pressure
5. Cooling water/engine temperature
6. Water detection-alert indicator
7. Battery voltage
8. Oil pressure (4-stroke models)
2
1
ZMU05415
2
3
1
4
5
6
7
8
ZMU05416
ZMU05931
6C1-9-26-1E0.book 38 ページ ２０１０年２月１０日 水曜日 午後１時５３分