6D55F11
4-12
1
2
3
4
5
6
7
8
9
NOTE:
• The float should be resting on the needle
valve
1
, but not compressing it.
• Take measurements at the float position
shown opposite its pivoted side.
Checking the Prime Start
1.
Measure the length of the Prime Start
plunger.
2.
Connect the Prime Start yellow (Y) leads
to a 12 V battery as shown.
3.
Measure the plunger length
a
after
applying power for the times indicated in
the following table. Replace if out of
specification.
4.
Measure the prime start resistance when
the prime start plunger length is 10.7 mm
(0.42 in).
Assembling the carburetor
1.
Install the main nozzle
1
, main jet
2
,
pilot jet
3
, and plug
4
to the carburetor
body as shown.
Float height
a
:
8.7–9.7 mm (0.34–0.38 in)
Prime Start plunger extended
length
a
(reference data):
10.7–15.4 mm (0.42–0.61 in)
Time (min)
Length (mm [in])
0
10.7 (0.42)
1
12.6 (0.50)
3
14.1 (0.56)
5
14.8 (0.58)
7
15.3 (0.60)
10
15.4 (0.61)
Prime Start resistance
(reference data):
Yellow (Y) – Yellow (Y)
17.7–18.7
Ω
at 20 °C (68 °F)
S6D54110
1
2
3
4
Carburetor
Summary of Contents for F2.5C
