For Service Engineer
Service Information
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
33/34
Warm up the machine (before wrapping the plastic wrap)
If it is before unwrapping the
plastic wrap
, put the drier between
the mounter and the wrap to warm
up the mounter and the air inside
the wrap. In this way, the mounter
can be warmed up
effectively
.
If the machine is covered with the
plastic wrap
, the condensation
occurs on the outer surface of the
wrap, and the drier is not required.
After a while, cut the plastic wrap with
scissors and unwrap it from the top.
Wrap the plastic wrap around
the machine from bottom up
before shipment.
