Yamaha Big Bear YFM400R, Owner'S Manual

Page: 28 / 170

4-5
EBU00053
Handlebar switches
1. Lights switch “ / /OFF”
2. Engine stop switch “ ”/“ ”
3. Start switch “ ”
EBU01205
Engine stop switch “ / ”
Make sure that the engine stop switch is set to
“
” before starting the engine. The engine
stop switch controls ignition and can be used
at all times to stop the engine, especially in an
emergency. The engine will not start or run
when the engine stop switch is set to “
”.
EBU00607
Start switch “ ”
The starter motor cranks the engine when this
switch is pushed.
CAUTION:
See starting instructions prior to starting
the engine. (See page 6-1 for details.)
_
EBU01204
Light switch “ / /OFF”
Set the switch to “ ” to turn on the low beam
and the taillight.
Set the switch to “
” to turn on the high
beam and the taillight.
Set the switch to “OFF” to turn off all the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
U5GW13.book Page 5 Tuesday, July 30, 2002 2:23 PM