STEP
Assemble Wheel Tray.
Assemble Pod and Skewer:
Tighten the screws using the
supplied hex wrench.
The pod must not rotate!
Attach the
pod cover.
Attach the
skewer nut.
Skewer direction is your choice;
consider lock access.
Position the pod
so that the front
dips slightly.
Assemble the
two halves of
the pod loosely
onto the
crossbar.
Single screw hole indicates FRONT.
FRONT
(side view)
Tighten until
there is no longer
a gap between
the pod halves.
Insert the carriage
bolt vertically into
the lower hole.
Compress the
strap into the red
button slots.
SQUARE BARS
ONLY:
The angled hole is for very
short or very wide crossbar
distances.
Attach SnapAround
LoadWarrior
users:
Attach the tube
sleeve onto the
crossbar.
Leave plenty of
skewer showing.
Insert the skewer while
applying pressure to
the pod cover.
Pod cover must
be in place at all
times for safe
operation of bike
carrier.
USE EXTREME FORCE WHEN TIGHTENING THE LEVER IN STEP 14. TEST THE INSTALLATION!
If you have square
bars, see last page for
SnapAround Instructions.
