33
CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
02: Load
The Load function is used to read a file from a USB flash-memory device into the instrument.
NOTE
Before carrying out the steps described below, ensure that the USB flash-memory device is plugged
into the instrument’s [TO DEVICE] USB terminal. If this is not the case, the instrument will display the
message “USB device not ready” instead of the Load screen.
NOTE
The Load function can only be used to read
All
-type files located in the USB flash-memory device’s root
directory. If no such file exists in the root directory, the instrument will display the message “File not
found” instead of the Load screen.
NOTE
The File menu is the first screen displayed when the [FILE] button is pressed.
NOTE
As shown in the following table, the load type indicates which data from the selected file is to be read
into the instrument.
Load types
Procedure
1. Press the [FILE] button.
2. On the File menu, use the [
d
] and [
u
] buttons to select
02: Load
, and then press the
[ENTER] button.
3. Use the [-1/NO] and [+1/YES] buttons or the Data Dial to select a file and load type, and then
press the [ENTER] button.
4. Carry out the steps for the selected load type as described below.
Format
Description
All
All data will be loaded from the selected
All
-type file (.C7A (CP4 STAGE) or
.C8A (CP40 STAGE) file extension).
All without Sys
(All without System)
All data other than Utility settings will be loaded from the selected
All
-type
file (.C7A (CP4 STAGE) or .C8A (CP40 STAGE) file extension).
Performance
One specific Performance will be loaded from the selected
All
-type file
(.C7A (CP4 STAGE) or .C8A (CP40 STAGE) file extension).