44
CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
04: MasterComp (Master Compressor)
The Master Compressor screen is used to set the following compressor parameters, which affect all
Performances.
CP4 STAGE:
FC2
(Foot Controller 2
Control Number)
This parameter can be used to specify the control change number for MIDI
messages produced in response to operation of the foot controller
connected via the [2] FOOT CONTROLLER jack. Any MIDI messages
received from an external source with this control change number will also
be treated as if they had been produced by Foot Controller 2.
Settings:
off and 00 to 95
NOTE
Settings of “00” and “32” have no effect on the instrument and do not
generate MIDI data.
CP40 STAGE:
FC
(Foot Controller)
This parameter can be used to specify the control change number for MIDI
messages produced in response to operation of the foot controller
connected via the [FOOT CONTROLLER] jack. Any MIDI messages
received from an external source with this control change number will also
be treated as if they had been produced by the foot controller.
Settings:
off and 00 to 95
NOTE
Settings of “00” and “32” have no effect on the instrument and do not
generate MIDI data.
Parameter name
Description
Preset
This parameter can be used to select one of the master-compressor
presets, which configure all parameters to suit a particular need.
Settings:
Basic, Maximizer, Wild, Attacky, Hard, Hip Club, and Slap Bass(ch)
LowTh
(Low Threshold)
This parameter can be used to set the input-signal level at which the
compressor starts to process the sound in the low-frequency band.
Settings:
-54dB to -6dB
LowAtk
(Low Attack)
This parameter can be used to set the amount of time that elapses between
arrival of an input signal and activation of the compressor in the low-
frequency band.
Settings:
1ms to 200ms
LowRat
(Low Ratio)
This parameter can be used to set the compression ratio for the low-
frequency band.
Settings:
1.0 to 20.0
LowGain
(Low Gain)
This parameter can be used to set the output level for the low-frequency
band.
Settings:
-∞ to +18dB
MidTh
(Mid Threshold)
This parameter can be used to set the input-signal level at which the
compressor starts to process the sound in the mid-frequency band.
Settings:
-54dB to -6dB
MidAtk
(Mid Attack)
This parameter can be used to set the amount of time that elapses between
arrival of an input signal and activation of the compressor in the mid-
frequency band.
Settings:
1ms to 200ms
MidRat
(Mid Ratio)
This parameter can be used to set the compression ratio for the mid-
frequency band.
Settings:
1.0 to 20.0
MidGain
(Mid Gain)
This parameter can be used to set the output level for the mid-frequency
band.
Settings:
-∞ to +18dB
Parameter name
Description