20
CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
02: Filter/EG (Filter & Envelope Generator)
LFOPMod
(LFO Pitch Modulation
Depth)
This parameter can be used to set the degree to which the LFO signal
produces periodic pitch changes for the current Part. The larger the setting,
the greater the range of pitch changes.
Settings:
-64 to +63
LFODelay
This parameter can be used to set how long it takes after pressing a key for
the current Part’s LFO to start generating a signal. The larger the setting, the
longer it will take for the LFO to have an effect.
Settings:
-64 to +63
MWPMod
(MW Pitch Modulation
Depth)
This parameter can be used to set the degree to which the modulation
wheel produces periodic pitch changes for the current Part. The larger the
setting, the greater the range of pitch changes.
Settings:
0 to 127
MWFMod
(MW Filter Modulation
Depth)
This parameter can be used to set the degree to which the modulation
wheel produces periodic changes in the filter cutoff frequency for the
current Part. The larger the setting, the greater the range of cutoff frequency
changes.
Settings:
0 to 127
MWAMod
(MW Amplitude
Modulation Depth)
This parameter can be used to set the degree to which the modulation
wheel produces periodic volume changes for the current Part. The larger
the setting, the greater the range of volume changes.
Settings:
0 to 127
KeyOffVol
(Key Off Sound
Volume)
This parameter can be used to recreate the sound of dampers pressing
against the strings when you remove your fingers from the keyboard. In
specific terms, the parameter sets the volume of this key off sound.
Settings:
-16 to +16
NOTE
This parameter cannot be set for certain Voices, and its setting is displayed
as “---” in such a case.
StrikPos
(Striking Position)
This parameter can be used to recreate the effect of changing the position
at which the hammers strike the resonators.
Settings:
top3, top2, top1, default, rear1, rear2, and rear3
NOTE
This parameter cannot be set for certain Voices, and its setting is displayed
as “---” in such a case.
Parameter name
Description
Cutoff
This parameter can be used to set the cutoff frequency of the filter used with
the current Part’s Voice.
Settings:
-64 to +0 to +63
Reso
(Resonance)
This parameter can be used to set the resonance of the filter used with the
current Part’s Voice.
Settings:
-64 to +0 to +63
Attack
(Attack Time)
Decay
(Decay Time)
Release
(Release Time)
These parameters can be used to define how the current Part’s sound will
change between pressing a key and fading away completely.
Settings:
-16 to +0 to +16
NOTE
Release
cannot be set for Parts with a Drum Voice, and its setting is displayed
as “---” in such a case.
Parameter name
Description