22
CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
06: Receive Switch
On the Receive Switch screen, you can enable (“on”) or disable (“off”) the receipt of Control
Change and other MIDI messages by the current Part.
NOTE
The MIDI messages produced by operating a foot switch or controller can be set on the Controller
screen (
) from the Utility area.
Parameter name
Description
Bank
(Bank Select)
This parameter can be used to specify whether the current Part’s Voice
assignment should be affected by MIDI Bank Select messages.
Pgm
(Program Change)
This parameter can be used to specify whether the current Part’s Voice
assignment should be affected by MIDI Program Change messages.
Vol
(Volume)
This parameter can be used to specify whether the current Part should
respond to MIDI Volume messages (Control No. 7).
Pan
This parameter can be used to specify whether the current Part should
respond to MIDI Pan messages (Control No. 10).
CC
(Control Change)
This parameter can be used to specify whether the current Part should
respond to MIDI Control Change messages.
NOTE
When this parameter is set to “off”, changes cannot be made to parameters
controlled by MIDI Control Change messages.
PB
(Pitch Bend Wheel)
This parameter can be used to specify whether the current Part should
respond to MIDI messages from a pitch bend wheel.
MW
(Modulation Wheel)
This parameter can be used to specify whether the current Part should
respond to MIDI messages from a modulation wheel.
Sus
(Sustain)
This parameter can be used to specify whether the current Part should
respond to MIDI Sustain messages (Control No. 64).
NOTE
This parameter cannot be set for Parts with a Drum Voice, and its setting is
displayed as “---” in such a case.
FS
(Foot Switch)
This parameter can be used to specify whether the current Part should
respond to MIDI messages produced by operating the bundled foot switch
connected via the [ASSIGNABLE] FOOT SWITCH jack.
CP4 STAGE:
FC1
(Foot Controller 1)
This parameter can be used to specify whether the current Part should
respond to MIDI messages produced by operating a foot controller (sold
separately) connected via the [1] FOOT CONTROLLER jack.
CP4 STAGE:
FC2
(Foot Controller 2)
This parameter can be used to specify whether the current Part should
respond to MIDI messages produced by operating a foot controller (sold
separately) connected via the [2] FOOT CONTROLLER jack.
CP40 STAGE:
FC
(Foot Controller)
This parameter can be used to specify whether the current Part should
respond to MIDI messages produced by operating a foot controller (sold
separately) connected via the [FOOT CONTROLLER] jack.