30
20 RPT.SET
In the factory default setting, [
20 RPT.SET
] is registered in the “Function List” that is
displayed when the [
F
menu
] key is pressed.
Set the Repeater shift direction
Set the TX frequency shift direction for repeater use.
SIMP
No TX frequency offset.
-SFT
Shifts TX to a lower frequency.
+SFT
Shifts TX to a higher frequency.
21 RPT.OTR
RPT.ARS (Set the ARS (Automatic Repeater Shift)).
Enable or disable the automatic Repeater Shift operation ARS (Repeater operation is
initiated by tuning to the repeater frequency).
OFF
Disables the ARS function.
ON
Set the repeater shift offset frequency.
RPT.FRQ (Set the Repeater Shift offset frequency)
Set the repeater shift offset frequency.
0.00MHz
-
99.95MHz
Repeater shift offset frequency (0.00MHz - 99.95MHz).
22 SCN.ON
Scan frequencies for signals
To find frequencies where there are signals in VFO mode, memory mode or PMG
mode.
23 SCAN TYP
SCN.RSM (Set the scan resume condition)
Select the receive operation when scanning is paused on a received signal.
BUSY
Scanning stops on a received frequency until the signal fades
out. Two seconds after the signal fades out, scanning re-
sumes.
HOLD
Scanning stops on the current receive frequency (Scanning
does not resume). Scanning may be resumed manually.
1 SEC / 3 SEC /
5 SEC
The signal is received for a specified period of time, and then
scanning resumes.
