14
Performing Programmable Memory Channel Scan
1. Recall the PMS memory channel to which the lower limit (Lxx) or upper limit (Uxx) of
the frequency band is registered.
2. Press and hold the microphone [
UP
] or [
DWN
] switch.
Programmable memory channel scanning starts.
•
During scanning, “
P
” and “
PMS.SCN
” appears on the display.
•
If the
DIAL
knob is rotated while scanning is in progress, the scanning will contin-
ue up or down in frequency according to the direction of the
DIAL
knob rotation.
•
If the scanner halts on an incoming signal, the frequency will blink.
•
The signal is received until the signal fades out. Two seconds after the signal
fades out, scanning resumes.
•
If the scan has paused on a signal, rotating the
DIAL
knob will cause scanning to
resume instantly.
3. Press the
PTT
switch or the [
UP
] or [
DWN
] switch of the microphone, to cancel the
scanning.
In this state, “
P
” is shown at the top of the display and the frequency can be changed
only in the range stored by the lower and upper PMS memories, by turning the
DIAL
knob.
z
Disable the PMS function
1. Press the [
V/M
mw
] key.
Returns to the normal memory mode.
