Yaesu FTM-6000R, Advance Manual

Page: 16 / 37

13
Skip Memory Channels
Each memory channel can be set to be skipped during memory scan.
1. Rotate the
DIAL
knob to select the Memory Channel to be skipped during scanning.
2. Press and hold the [
V/M mw
] key.
3. Rotate the DIAL knob to select “ SCAN ”.
4. Press the DIAL knob.
5. Rotate the DIAL knob to select “ SCAN N ”.
6. Press and hold the [ V/M mw ] key.
The channel is programmed to be ignored during
memory scanning.
To return a channel into the scanning, select “ SCAN ” in
step 5 above.
Scan skip settings cannot be set for the PMS memory
channels: L01 / U01 to L50 / U50.
Programmable Memory Channel Scan (PMS)
The FTM-6000R/E can be set to tune or scan only the frequencies between user defined
lower and upper band limits.
Registering to the Programmable Memory Channels
50 sets of PMS memory channels (L01/U01 to L50/U50) are available.
1. Select the desired lower-limit scan frequency.
2. Press and hold the [
V/M mw ] key.
3. Rotate the DIAL knob to select Lxx (L01 to L50).
4. Press and hold the [
V/M mw
] key.
5. Select the desired upper-limit scan frequency
6. Press and hold the [
V/M mw ] key.
7. Rotate the DIAL knob to select Uxx (same number
as step 3).
8. Press and hold the [ V/M mw ] key.
• Make sure to use the corresponding numbers for the lower and upper limit memory
channels.
• Set the Programmable Memory scanning (PMS) lower and upper limits as follows:
• The lower and upper limit memory channels must be within the same frequency band.
• The lower and upper limit memory channels must not be registered in reverse.