52
5 Setting the direction of the repeater shift
Set the direction of the repeater transmit shift setting.
1. Press and hold the [
F(SETUP)
] key
[
CONFIG
]
[
5 RPT SHIFT
]
2. Press the
DIAL
knob to select the shift direction setting.
OFF
The transmit frequency will not shift.
-
The transmit frequency will shift down.
+
The transmit frequency will shift up.
The default setting: OFF
6 Setting the shift width of the repeater
Set the repeater transmit shift offset frequency.
1. Press and hold the [
F(SETUP)
] key
[
CONFIG
]
[
6 RPT SHIFT FREQ
]
2. Rotate the
DIAL
knob to select the desired repeater transmit shift offset.
The offset can be set at 0.05 MHz intervals between 0.00 MHz and 99.95 MHz.
The default setting differs depending on frequency
7 Setting the frequency tuning step
Set the frequency step when the tuning knob is turned, or when the key is pressed.
1. Press and hold the [
F(SETUP)
] key
[
CONFIG
]
[
7 STEP
]
For details, refer to the Operating Manual.
8 Setting the volume of the beep
Adjust the volume of the beep that sounds when a key is pressed.
1. Press and hold the [
F(SETUP)
] key
[
CONFIG
]
[
8 BEEP
]
2. Press the
DIAL
knob to select the desired setting.
The Beep volume can be selected from 3 levels.
OFF / LOW / HIGH
The default setting: LOW
9 Setting the clock shift of the CPU
The CPU clock signal can be changed so that an internal spurious signal it is not heard
by the receiver. Select “A” during normal operation.
1. Press and hold the [
F(SETUP)
] key
[
CONFIG
]
[
9 CLOCK TYPE
]
2. Press the
DIAL
knob to select the desired setting.
A
The clock shift operation will automatically switch ON and OFF.
B
The clock shift will always be kept in operation.
The default setting: A
