18
Setup Your Bolide
02
5.
From the menu toolbar, click
Tools > Board
and select the option
XYZrobot-BOLIDE
.
6.
Next, select the COM port associated with the Bolide Crawler. From the menu toolbar, click
Tools > Serial Port
and select the associated option.
NOTE:
If the device is not detected, the USB driver may not be recognized. The option to select
the associated COM port will not be available. You will need to update or re-install the
serial port drivers; see
7.
Click
(Verify) to compile the codes.
After compiling, the message
Done compiling
displays on the bottom of the frame.
If there are no errors and the compiling is complete, upload the code to the MCU board.
8.
Click
(Upload) to upload the codes.
After uploading, the message
Done uploading
displays and no error is identified at the bottom
of the frame.
