21
FW: 841013-005/843003-001
Turbidity and Suspended Solids Transmitter
EN 5.10 SuSix Manual 2007
Installation / Removal using Insertion Fitting 155210
Warnings: Max. operating pressure is 6 bar (720 N).
Max. residual pressure when changing sensor is 1 bar (120 N).
The sensor guide (2) is not a safety component
The insertion fitting is not fully assembled from the factory
Be careful when dealing with corroding and toxic substances
Be careful when dealing with lines under pressure
Required Tools and Materials
• 5 mm hex key
• LOCTITE
®
577 sealant
T
7
1
2
3
4
5
6
Measure position Service position
A
B
Preparing the Insertion Fitting before welding to tube
The nuts on the ball valve housing (see A and B arrows)
have not
been
tightened and secured with a sealant from the factory. This allows the
customer to rotate, position and secure the ball valve as required on the
installation site.
1. Loosen/remove the A and B nuts, and rotate the ball valve to its final
position.
