pHix® Compact V3. NG (next generation)
EN 4.10 Version 2202
1
http://www.mjk.com
Introduction /Measurements and standards used
7
1.
2.
3.
Introduction
Thank you for choosing our pHix® Compact pH/Redox transmitter. We have done
everything possible to make a pH / Redox transmitter that can fulfill all your demands.
pHix® Compact is very simple to install and connect, as electrode, fitting and transmitter
is built together in the same NEMA 6X / IP 68 class enclosure. By doing so, all error
sources like e.g. bad cable connections and leaking fittings are eliminated.
As pHix® Compact is equipped with an union flange in one end and male thread in the
other, the transmitter is very easily mounted in open tanks as well as pipes.
You can always contact your representative or the MJK Support for advice and
guidance. Also, take a look at
pHix® Compact is registered trademark of MJK.
Measurements and standards used
This manual uses both the US standard measurement system (inches), Fahrenheit and
North American industry standards and the metric measurement system, Celsius and
European industry standards and side by side.
Safety instructions
Read this manual carefully.
Be aware of the environment on the installation site. Wear necessary protective
equipment and follow all current safety regulations.
Always ensure that connected machinery and other equipment are effectively
being put out of service (i.e.by log out/tag out) before commencing setting, fault
finding, service and maintenance work etc.
Repair
Repair must only made by MJK or by a service representative approved by MJK.
Explosion hazardous areas
Note!
pHix® Compact must
not
be installed in explosion hazardous areas!
