Chapter 4 - SCSI Installation (XVME-956/412)
Default:
A
T
interrupt level = 11
Specify /qx to change this value, where "x" is the desired interrupt level and must be
one of the following: 09, 10, 11, or 12. The interrupt level switches described, at the
end of the chapter, must be set to match the level chosen by this option.
Default:
A
T
I/O address range = 340h-35fh
Specify /p140 to select I/O range = 140h-15fh. The I/O base address switch,
described in Appendix A, must match this selection, even if it is the default value.
Default: M i n i m a l messages displayed during drive installation
Specify /d to display useful debugging information during installation.
Default: O n l y LUN=O will be the address for each SCSI target.
Specify /1 to cause all LUNs to be addresses when determining which logical units are
present on the SCSI bus.
As
an
example of command line option usage, consider the case where the following options are
desired: disconnect enabled, parity enabled, synchronous negotiation enable, SCSI target number = 5,
interrupt level = 12, and I/O base address =340h. The following line should appear in config.sys to
effect these options:
device= <path> aspi2dos.sys /z /y- /h5 /q12
4.2.2.2 A S P I D I S K . S Y S
This driver requires the drive to be partitioned by the AFDISK routine prior to driver installation (see
Section 4.2.2). I f the drive has not been partitioned, the driver will not load and will display an error
message.
Aspidisk.sys has two default values:
Default: M i n i m a l messages displayed during drive installation
Specify /d to display useful debugging information during installation.
4-4
•
•
•
