•
•
•
XVME-956 Manual
August 1994
4.2.2 D r i v e r Installation
The ASPI2DOS.SYS and ASPIDISK.SYS files need to reside on the boot device. Copy these files, as
well as the AFDISK subdirectory files, to that drive. F o r convenience, you can store these files in a
subdirectory.
ASPI2DOS.SYS and ASPIDISK.SYS need to be loaded via the config.sys command file. These
drivers require at least twenty buffers and twenty files. This information is defined in the config.sys
file as follows:
buffers = 20
files =20
device = <path> aspi2dos.sys / z options
device = <path> aspidisk.sys options
4.2.2.1 A S P I 2 D O S . S Y S Options
Several
non-default options can be specified when installing the aspi2dos.sys driver. These options are
specified in the config.sys file on the line which invokes the driver. Command line options may be
entered in any order and may be upper o r lower case.
Several default values are assumed by the driver. These values may be changed from their default by
specifying additional command line options. The default values and their associated command line
options are described below:
Default: S C S I disconnect option enabled
Specify /c to disable this option.
Default: S C S I parity option disabled
Specify /y- to enable this option.
Default: S C S I synchronous negotiation option enabled
Specify /u- to disable this option.
Default: S C S I target number 7
Specify /hx to change this value, where "x" is the desired target number from 0
through 7 inclusive.
4-3
