Xycom AHIP-370, Manual

Page: 29 / 65

Chapter Three – BIOS Setup Menus
29
Option Description
IDE Primary Master
IDE Primary Slave
IDE Secondary Master
IDE Secondary Slave These items show the IDE configuration and allow entry into the IDE sub-
menus.
System Memory Displays the amount of conventional memory detected during boot-up. This
field is not user configurable.
Extended Memory Displays the amount of extended memory detected during boot-up. This field is
not user configurable.
Cache RAM Displays the amount of cache detected and allows entry into the cache submenu.
IDE Submenu
Xycom BIOS Setup Utility
Main
IDE Primary Master (C: 1082 Mb) Item Specific Help
Type: [Auto/User]
* Cylinders: [ 2097] If the line item you
* Heads: [ 16] are viewing has
* Sectors [ 63] specific help, it will
* Maximum Capacity 1082 Mb be listed here.
* Multi-Sector Transfers: [8 Sectors]
* LBA Mode Control: [Enabled]
* 32-Bit I/O: [Disabled]
* Transfer Mode: [Fast PIO 4]
* Ultra DMA Mode [Disabled]
F1 Help
↑↓
Select Item -/+ Change Values F9 Setup Defaults
ESC Exit
←→
Select Menu Enter Select » Submenu F10 Save and Exit
Figure 3-2. IDE Adapter Submenu
The IDE submenus are used to configure IDE hard drive information. If
only one drive is attached to an IDE adapter, then only the parameters in
the Master Submenu need to be entered. If two drives are connected,
both Master and Slave Submenu parameters will need to be entered. All
IDE submenus contain the same information and operate the same.
Table 3-2. IDE Adapter Submenu Options
Option Description
Type Options include Auto, None, CD-ROM, other ATAPI, and User. “Auto” autotypes at each
boot. “None” indicates no device is attached. “CD-ROM” indicates that a CD-ROM drive
is attached. “Other ATAPI” indicates that a removable disk drive is attached. “User” al-
lows the user to specify device parameters.
1, 2
Cylinders Indicates the number of cylinders on the hard drive. This information is automatically
entered if Type is set to “Auto.”