5015T Flat Panel Industrial Monitor
Chapter 3 Monitor Settings
17
Video Modes Supported
Mode
Horizontal
Sync Rate
(KHz)
Vertical Sync
Rate (KHz)
Dot Frequency (MHz)
(640x400)
(640x480)
(720x400)
(800x600)
(1024x768)
31.469
31.469
37.500
35.000
31.469
37.879
46.875
48.363
56.476
60.023
70.000
59.992
75.000
66.667
70.000
60.317
75.000
60.004
70.069
75.029
25.175
25.175
31.500
30.240
28.320
40.000
49.500
65.000
75.000
78.750
NOTE:
All are compliant only with non-interlaced.
If the monitor is receiving timing signals that are not compatible, [OUT OF TIMING] will
appear. Follow your computer’s instruction manual to set the timing so that it is compatible
with the monitor.
If the monitor is not receiving any signal (synch signal), [NO SIGNAL] will appear.
NOTE:
All adjustment will be retained even after turning the power off. (However, please note that
adjustment may not be retained when the monitor is turned off while displaying the Adjustment
Menu.)
Adjusting the Backlight
The backlight brightness can be adjusted while the On Screen Display (OSD)
Menu is not being displayed. When the OSD Menu is being displayed, press
Menu
button
(several times may be required) to escape OSD Menu. Then proceed to make the necessary
adjustments.
1. Without the OSD Menu displayed, push the or the button.
2. Pressing the button decreases the brightness level, and pressing the button
increases the brightness level. The BRIGHT bar automatically disappears approximately 5
seconds after the last command.
Setting Color Mode
Color tone can be set as below. Set by using COLOR MODE.
STD
Displays image with the color tone results from original scheme of liquid crystal panel.
sRGB
SRGB is the international standard of color representation specified by the IEC (International
Electrotechnical Commission).
Color conversion is made by taking into account the liquid crystal’s characteristics and represents
color tone close to its original image.
NOTE:
When you use this monitor in sRGB mode, set WHITE BALANCE to STD.
