Installing Light and Emergency Release Knob
To install the light:
1.
Pull the Lamp Dome from the top and detach it from the
Opener.
2.
Install a standard A19 (E26) 100 watt maximum light bulb.
3.
Re
-
attach the Lamp Dome.
Notice
When replacing the light bulb, make sure the bulb on the Opener
has cooled down to prevent injury.
!
WARNING
To prevent SERIOUS INJURY or DEATH from electrocution:
-
Disconnect power cord before installing/replacing light bulb.
To prevent possible OVERHEATING or damage to Opener:
-
Use ONLY A19 (E26) incandescent bulbs* (100W max.).
-
DO NOT use short neck or specialty light bulbs.
-
DO NOT use halogen bulbs.
* CFL or LED light bulbs will work but may interfere with hand
-
held transmitters
6 feet (1.83m) above floor
To attach the Emergency Release Knob:
1.
Thread one end of the rope through the hole of the
Emergency Release Knob and secure with an overhand
knot.
2.
Thread the other end of the rope through the hole in the
Trolley lever.
3.
Measure the rope length so that the knob is 6 feet (183cm)
above the floor and is clear from the top of your vehicle.
Secure with a overhand knot.
Fig. 1
Fig. 2
!
WARNING
To prevent SERIOUS INJURY or DEATH from a falling garage door:
-
In case of power failure or door obstruction, PULL EMERGENCY HANDLE to release door from Open-
er.
-
When Emergency Release is in the released position, the door can be operated manually.
-
To reconnect, flip the lever on the Trolley towards Opener, back to Connect position, it will reconnect
automatically upon pressing wall panel or remote control.
-
DO NOT use Emergency handle to pull the door open or closed.
Lever
Emergency Release Knob
11
Lamp Dome
* VERY IMPORTANT! *
Emergency Release Knob must clear all vehicles. An
Emergency Release Knob set too low may get caught by
the vehicle and cause damage to the opener. Measure
from the floor to the top of your vehicle and set the
Emergency Release Knob above this measurement.