Connecting Wall Panel
14
!
WARNING
To prevent SERIOUS INJURY or DEATH from electrocution:
-
Power MUST NOT be connected until instructed.
To prevent SERIOUS INJURY or DEATH from using the Wall Panel and a closing door:
-
Install the Wall Panel within sight of the door at a minimum height of 5 feet (1.5m) above the floor.
Make sure it is out of the reach of children and moving parts of door and hardware.
-
NEVER permit children to access the Wall Panel or remote Transmitters.
-
Operate the door ONLY when it is adjusted properly with no obstructions present and is in clear sight.
-
ALWAYS keep a moving door in sight until it’s completely closed.
-
NEVER cross the path of a moving door.
NOTICE: Use Xtreme brand wall panel only. Use of other brands of wall panels or buttons may cause
issues or damage to your opener.
To Connect the Push Button to the Opener
Connect the pair of wires from the Push Button to the pair of
“PUSH BUTTON” terminals on the rear of the Opener. Refer to
Wiring Instructions
on page 12 to ensure wires are properly
connected.
The Push Button is a wired, illuminated door control placed
inside your garage.
To install the Push Button:
1.
Inside your garage, install the rear cover of the Push
Button within sight of the door at a minimum height of 5
feet (1.5m) off the ground. Ensure it is installed out of the
reach of children and free from the moving parts of the
door and hardware.
2.
With the “Bell” icon on the rear cover facing you, securely
fasten it to a solid surface with 1” screws. If attaching to
drywall or other hollow surface, drill 3/16” holes and use
the provided Drywall Anchors.
3.
Snap the Push Button onto the rear cover
.
Push Button
Min. 5 feet (1.5m)
above floor
From Push Button
Drywall Anchor
Screw #6 x1”
