XTEMP ENVIRONMENTS (SHANGHAI) CO., LTD.
http://www.xtemp-usa.com/
25
/
31
DSGO0708-2-V211119/UXP8011-CD6400/CLASS I/NFL/RT+5~+100°C
Chapter 3 Controller Descriptions and Operation
3
SEt
value and actual temperature.
4)
The equipment may be initiated immediately when
is operated regardless of the
remaining
AS
time.
3.7 Timer for automatic terminating (optional)
1)
The function of timer is optional.
2)
Press
for more than 2 seconds to display
Ht
, scroll the menu by
until
ASd
is
displayed, then press
to enter. Press
to get the desired value, press
to
confirm and exit the
SEt
screen or exit automatically in 4 seconds.
5)
When the equipment is in running mode, press
+
at the same time and then release
to initiate timing. The timer starts to count down. When the time of
ASd
elapses, the
circulation pump and heating will stop automatically to terminate constant temperature
control.
6)
The equipment may be terminated immediately when
is operated regardless of the
remaining
ASd
time.
3.8 Temperature Programming (optional)
1)
The function of temperature programming is optional.
2)
Press
and
at the same time and then release. The parameter of first segment
t1
is
displayed. Press
to display original time, press
for a new value, confirm the
setting by pressing
to display temperature of the first segment
M1
; Press
to display the
original temperature, press
for a new value, confirm the setting by pressing
to
enter the setting of second segment.
3)
Following the steps as for the first segment for segments 2, 3 … to 6 maximum. If segments of
less than 6 are desired, for example only 2 segments are necessary, use
00
:
00
for
t3
after
confirmation of
M2
.
4)
Press
to display
n
, which means the number of program circles.
1
～
99
means 1 cycle to 99
circles maximum and
0
means unlimited circles. Press
to confirm and exist.
5)
Press
and
at the same time to initiate or terminate programming. The program may
be terminated immediately when
is operated regardless of the remaining program
segments.
6)
When the programming is in progress, press
shortly to display the segment number,
temperature, remaining time and cycles of active program. The parameters are cycled and
displayed for 2 times with each delay of about 2 seconds, and then exit automatically.
