xsto CT420S, Operation Manual

Page: 27 / 58

23
greater than 30°, the loading board will be depressed to 30°(In case of
less than 7°, see the second precautions).
(2) Restore the last used auto angle
When the CT420S switches to manual mode from automatic mode,
CT420S will retain the horizontal included angle of loading board during
mode switching (assuming the angle is 15°).
When the CT420S is under manual adjustment mode and the horizontal
included angle of the loading board is less than 7°. Then switch to the
automatic adjustment mode, the loading board will be adjusted to the
angle when the last automatic adjustment mode is switched to the
manual adjustment mode (the angle of the previous section is restored
to 15°).
Note: this angle is not saved after the machine is powered off, and is
only valid when the machine is continuously used after power on.
(3) When the machine (lithium battery switch) is powered on, the
automatic adjustment default angle is : 10 °
After the CT420S (lithium battery switch) turns on, it switches to the
automatic adjustment mode for the first time with the horizontal angle
less than 7°. At this time, The CT420S will adjust the horizontal angle of
loading board to 10°.
Switch to the automatic adjustment mode when it is more than 7°, and
the adjustment of the loading board shall be subject to the 3.5.1(1).
(4) If it is found that the hand-held Controller is in the state of speed